,cnc machinist,cnc manufacturing,cnc mechanic,cnc mill,cnc milling center,cnc milling companies,cnc milling tools,cnc parts,cnc plasma cutter,cnc plasma cutting,cnc plasma table,cnc production,cnc router table,cnc screw machine,cnc service,cnc swiss,cnc turning,cnc turning center,cnc turning centers,cnc vertical lathe,horizontal cnc,how to cnc machine,machining cnc,manufacturing cnc machines,okuma cnc,plasma cnc machine,production cnc machining,troubleshooting cnc machines,used cnc machine tools,used cnc milling machines,vertical cnc lathe,what can a cnc machine make
Four university students (Aaron, Ananda, Matt & Michael) created an upgrade kit and guide for RepRapPro Huxley model. The upgrade includes: laser cut frame is in 6mm MDF, z axis bracket, fan upgrades and maintenance guide.They also summarized the maintenance needed for Huxley model:
Daily
- Use acetone based cleaning solution (nail polish remover will work) to wipe the bed, ensure it is not heated.
- Ensure rear fans are clear of cable obstruction.
- When feeding filament ensure it has a pointed end, this will help its feeding into the hot-end and extruder.
- Ensure the y axis linear rods are in place in the supports.
- Ensure that the nut holding the x axis idler is finger tight.
Weekly
- Run the printer fans for no less than 3 minutes before print to ensure smooth operation.
- All the daily checks plus:
- Ensure all the nuts are tight (there are 48 of them).
Monthly
- Check that all 6 bearings are in place.
- All the Daily and Weekly checks plus:
- Cleaning the nozzle: Raise the z axis 50mm from home and the hot-end to 200 through 'Pronterface'. Clean the nozzle of any excess material using a wooden spatula or knife **CAUTION** THIS MUST BE DONE WITH EXTREME CAUTION, the hot-end is at up to 250 degrees C!
- Check belt tension on x and y axis. (refer to assembly instructions)
- Check that all five steppers are firmly attached to the frame/supports.
- Tighten the U brackets connecting the z axis motors to the threaded rods.
- Check end stops for wear.
- Grease linear rods x6 with WD-40 or similar lubricant.
- The electric connectors and screws should be checked for tightness.
- Check bed wires for integrity replace if worn.
Here is Instructables page with all the details:
http://www.instructables.com/id/RRP-Huxley-FU-Fanned-Up-Improvements-to-the-Huxley/?ALLSTEPS
Thingiverse page (not public at the moment):
http://www.thingiverse.com/thing:74001